0 Items

Spiral bevel gears are typically created from hardened steel. The teeth of these gears are often ground for a far more precise finish enabling little sound at high speeds. You can specify left hands or right hand based on the direction you have to run the gears

If you have a high speed application that will require a lot of torque then spiral bevel gears certainly are a great option. The gears operate at 90° to one another and also have “spiral” shaped the teeth which gives maximum tooth surface get in touch with while rotating. With get in touch with spread over the complete tooth the spiral bevel gear could be run much faster compared to the straight tooth bevel equipment and handle harder begins and stops.

We make spiral bevel gears only for industrial applications.

Worm gears are found in large equipment reductions. Gear ratio ranges of 5:1 to 300:1 are normal. The setup is designed to ensure that the worm can turn the gear, however the equipment cannot convert the worm. The position of the worm is usually shallow and because of this the gear is held in place because of the friction between your two. The gear is situated in applications such as for example conveyor systems in which the locking feature can act as a brake or a crisis stop.

The model spiral gear china cross-section shows a typical placement and usage of a worm gear. Worm gears possess an inherent safety mechanism built-in to its style given that they cannot function in the reverse direction.