aaa
1 2 3
  
 
 

Contact

 

XinLan Coupling Co., Ltd.

Phone: 1308388828

Website: www.gear-reducers.com

Address: Hangzhou Industrial Development Zone, Zhejiang Province

  Service Hotline:

 

  0317-839882

 

How to achieve non-destructive testing for plum blossom coupling forgings

Article source: www.gear-reducers.comEditor in charge: XinLan couplingPopularity:1218发表时间:2019-04-14 17:46:08
 

Plum coupling锻件如何做到无损检测

1、	梅花Coupling锻件一般要求应无裂纹、白点、折叠、严重的锭型偏析和严重的非金属夹杂物。

2、	梅花联轴器锻件超声波检验按JB/T1581-1996或JB/T1582-1996的规定进行。超声波控伤其要求如下:
A.	当量直径小于2mm的单个分散的缺陷不计,但应记录,并报告需方;
B.	不允许有当量直径大于5mm缺陷存在;我厂生产齿式联轴器.
C.	如有密集缺陷,双方协商处理。
3、	当需方的锻件图样上有规定时,锻件磁粉检验应在精加工后按JB/T6063-1992的规定进行。磁粉检验其要求如下:
A.	长度不小于1mm的缺陷应记录其位置;
B.	不允许有长度大于5mm的缺陷性的磁粉堆积存在;我厂生产弹性柱销联轴器.
C.	位于同一母线上的线性缺陷间的距离小于其中较大缺陷长度的3倍时,按一条计;
D.	长度大于5mm的缺陷,在图样规定的公差范围允许局部磨去,抛光后重新检验。
4、	梅花联轴器锻件金相试验按YB/T5148-1993的规定测定晶粒度,实际晶粒度不得粗于4级。
5、	梅花联轴器锻件的尺寸和表面粗糙度应符合需方提供的图样的规定。选Diaphragm coupling到XinLan.

XinLan Coupling Co., Ltd. is an enterprise specializing in the research and production of couplings and brackets.The main products are diaphragm couplings, elastic pin couplings, gear couplings, tire couplings, plum couplings, etc.