The EP Greenhouse reducer is a concise and lightweight reduction reducer with an integrated limit switch system that’s suitable for assembly of a locally available electric electric motor. The geared motor is used in manually-controlled or climate-controlled ventilation and display screen systems in greenhouses. The quick and easy-to-install EP geared motor is rainproof and windproof. The gear motor has a high protection course (IP65) and can be utilized in an ambient temperature of 0-60 °C.
The low-noise gear motor for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny means that the drive shaft is usually locked when the reduction gear driver isn’t running. The completely sealed reduction gear driver comes with an growth chamber with a diaphragm to keep carefully the gear oil at a minimal pressure under all situations, even at high temperatures. Thanks to the use of an growth chamber, the reducer can be installed in any placement. There are no restrictions, because there is no need for a bleed connect. The sealed reduction gear motor keeps the gear essential oil of the geared motor in optimal condition because of its entire operating life time. The reducer is ideal for discontinuous use, operating class s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gear motor comes with an FT85 motor assembly flange, on to which the right IEC standard motor can certainly be installed (EN 50347).
The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit change system is installed within an integrated chamber and is enclosed by an impact-resistant plastic-type cover. The limit switch system is accessible and simple to adjust. The limit switch system’s optimum switching range is 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The reducer for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of software of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temperature ranges of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, optimum activation time 25 moments.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching range of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).